The anaerobic thread locking to avoid loosening and leakage of threaded fasteners. For M6-M36 thread locking and sealing. Prevent thread corrosion.
Typical uses: screw locking.
Base chemical composition: methyl methacrylate
Appearance: Red viscous liquid
Viscosity (mPa.s): 1000-3000
Specific Gravity: 1.05
Flash point (° C):>108
Maximum fill the gap (mm): 0.13
Room temperature curing time (min): ≤ 20
After curing properties:
Full cure time at room temperature (hr): 24
Destruction of torque (Nm): 3-12
The average removal torque (Nm): 2-10
Operating Temperature (° C): -54 ~ 149
Instructions for use:
painted surfaces should be clean, dry and no oil.
bolts painted in sufficient quantity to fill all engaged threads, a thin layer of the product results in a 0.05 mm or less work best.
For large thread sizes, the larger the gap will affect cure speed and strength of the product. This product will reduce the friction force (torque tension ratio) assembly generated. Need to be fastened to the threaded applications critical value, the need to determine in advance a good ratio.
The anaerobic thread locking should not be used on plastic parts; in order to avoid contamination of the original glue, do not have poured the glue back to the original packaging.
The anaerobic thread locking containing methyl acrylate, skin and eye irritation. If skin contact, immediately wash with water; If contact with eyes, rinse immediately with water and go to the hospital for treatment.
Storage conditions: in the temperature range of 15 ~ 28 ° C in a cool, dry place sealed, shelf life of up to 12 months.
1 x Kafuter K-022250ML